LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Traverse High Country, 4WD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Front Brake Hose Replacement >> Removal Procedure

Removal Procedure

WARNING:

Brake Dust Warning

WARNING:

Brake Fluid Irritant Warning

  1. Raise and support the vehicle. Lifting and Jacking the Vehicle
  2. Remove the tire and wheel assembly. Tire and Wheel Removal and Installation
  3. GM4289790Courtesy of GENERAL MOTORS COMPANY

    Brake Pipe Fitting (1) - Disconnect

  4. Cap the brake pipe fitting to prevent brake fluid loss and contamination.
  5. GM4289791Courtesy of GENERAL MOTORS COMPANY

    Brake Hose Bracket Nut (1) - Remove

  6. GM4261516Courtesy of GENERAL MOTORS COMPANY

    Brake Hose Fitting Bolt (1) - Remove

  7. GM4261517Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Do NOT reuse the brake hose fitting gaskets.

    Brake Hose Fitting Gasket (1) @ Brake Hose Fitting (2) - Remove and DISCARD [2x]

  8. Plug the brake caliper inlet to prevent brake fluid loss and contamination.
  9. Front Brake Hose - Remove
scientia non olet · About LEMON Manuals