LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Controls And Fuel - 2.0L (LTG) - Diagnostic Information And Procedures (2 Of 2)) >> Diagnostic Information and Procedures >> DTC P157A or P16D7-P16D9 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition/Vehicle - Off
  2. Verify the condition does not exist: - LooseGround connection @G120
    • If a condition exists 

      Repair or replace as necessary.

    • Go to next step: If no condition exists 
  3. Disconnect the electrical connector:K111 Fuel Pump Driver Control Module
  4. Test for infinite resistance between the test points:Terminal 16@Component harness & Ground
    • If less than infinite resistance 

      Repair the short to ground on the circuit.

    • Go to next step: If infinite resistance 
  5. Disconnect the electrical connector: X4 @ K9 Body Control Module
  6. Test for less than 1 V between the test points:Terminal 16@Component harness & Ground
    • If 1 V or greater 

      Repair the short to voltage on the circuit.

    • Go to next step: If less than 1 V 
  7. Test for less than 2 ohms between the test points:Terminal 16@Component harness & Control circuit terminal 22@Control module harness
    • If 2 ohms or greater 

      Repair the open/high resistance in the circuit.

    • Go to next step: If less than 2 ohms 
  8. Replace the component:K9 Body Control Module
scientia non olet · About LEMON Manuals