Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Verify the engine cranks.
- If the engine does not crank
  Refer to Starter Malfunction (Without KL9) , or Starter Malfunction (KL9) .
- Go to next step: If the engine cranks
Ignition ON.
Verify DTC P0562 or P0563 is not set.
- If DTC P0562 or P0563 is set
  Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- Go to next step: DTC P0562 or P0563 is not set
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
  Refer to Circuit/System Testing.
- Go to next step: If the DTC does not set
All OK.