Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Raise the vehicle. Lifting and Jacking the Vehicle
Loosen the transmission rear mount bolt (1) at the transmission rear mount (5).
- Position two floor jacks with wood blocks under the engine and transaxle in order to support the powertrain assembly.
- Lower the vehicle. Lifting and Jacking the Vehicle
Loosen ONLY the engine mount to engine mount bracket bolts (1). Engine Mount Replacement
- NOTE:
Only the transmission mount transmission side bolts (3) should be loosened. Transmission mount bolts (4) should remain tightened during the balancing procedure.
Loosen ONLY transmission mount transmission side bolts (3) at the transmission mount (5). Transmission Mount Replacement (Left Side)