Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Drain the engine oil. Engine Oil and Oil Filter Replacement
- Support the engine. Engine Support Fixture
- Oil Pump Flow Control Valve Heat Shield - Remove - Oil Pump Flow Control Valve Heat Shield Replacement
- Engine Front Cover - Remove - Engine Front Cover Replacement
- Exhaust Front Pipe - Remove - Exhaust Front Pipe Replacement (LTG)
- Remove Transmission Rear Mount Bracket-
Catalytic Converter Brace Bolt (1) - Remove [4x]
- Catalytic Converter Brace (2) - Remove
- Warm Up Three-Way Catalytic Converter - Remove - Warm Up Three-Way Catalytic Converter Replacement (LTG)
- Engine Oil Cooler - Remove - Engine Oil Cooler Replacement (LTG)
Air Conditioning Compressor Bolt (1) - Remove
Transmission Bolt (1) - Remove
Remove the oil pan to transmission bolts. (1, 2) - Remove
- Oil Pump Flow Control Valve Heat Shield - Remove - Oil Pump Flow Control Valve Heat Shield Replacement
Disconnect the electrical connector. (1)
- Retainer (2) - Remove [2x]
- Remove the front axle shaft assembly bolt (3).
Remove the long oil pan bolts (3), medium bolt (2) and short bolts (1), then remove the oil pan.
- Clean and inspect the oil pan. Oil Pan Cleaning and Inspection
- Transfer components as necessary.