Engine Front Cover Removal

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Remove the accessory drive belt tensioner bolt (1).
Remove the accessory drive belt tensioner (2).
Courtesy of GENERAL MOTORS COMPANY

Remove the engine front cover bolts (2 - 7, 9).
Discard bolts 3, 5, and 6.
Remove the engine front cover (1).
Ensure proper use of room temperature vulcanizing (RTV) sealant. Use of Room Temperature Vulcanizing (RTV) and Anaerobic Sealant
Clean and Inspect the engine front cover mating surface.
Remove the front oil seal (8) with an appropriate tool.