Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Install the transmission control lever knob (3) to the transmission control lever.
- Connect the park brake switch electrical connector.
- Insert the rear locating tab (2) into the front floor console.
- Seat the front retainer (1) of the bezel into the front floor console.
- Turn the ignition switch to On position, engine Off.
- Place transmission control in the Park position.
- Un-apply the parking brake.
- Turn the ignition switch to the Off position.
NOTE:
Pull up on the shift knob after installation, to ensure the knob clip is locked in place.