Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Install the control valve body cover (1).
- NOTE:
The number (1) bolts are stud bolts.
Hand start the control valve body cover bolts (1, 2).
- Install the control valve body cover bolts. Tighten the bolts in sequence to 11 N.m (97 lb in).
- Install the body ground cable and wiring harness assembly to the front of transmission.
Connect the transmission fluid cooler outlet pipe (1) to the transmission.
- Connect the transmission fluid cooler inlet pipe (2) to the transmission.
Connect the control valve body transmission control module electrical connector (1), then clip the wiring harness to the cover.
- Fill the transmission with correct fluid. Adhesives, Fluids, Lubricants, and Sealers
- Check transmission fluid level. Transmission Fluid Level and Condition Check .
- Install the transmission control module bracket. Transmission Control Module Bracket Replacement
- Install the charge air cooler outlet air tube. Charge Air Cooler Outlet Air Tube Replacement .
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (Without KL9) , or Battery Negative Cable Disconnection and Connection (With KL9) .
- Check for leaks.
CAUTION:
Refer to Fastener Caution .
NOTE:
Install all control valve body cover bolts and stud bolts by hand then torque all bolts in sequence.