LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission - 9T50 (M3E) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Automatic Transmission Range Selector Lever Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Set the park brake and chock the wheels.
  2. Reposition the engine control module. Do NOT disconnect the wiring harness connectors. Position the engine control module aside. Engine Control Module Replacement
  3. GM5138546Courtesy of GENERAL MOTORS COMPANY

    Automatic Transmission Range Selector Lever Cable Bolt (1) - Remove

  4. Slide the retainer lock (2) forward to expose the cable adjustment retainer (3).
  5. Using a suitable tool, raise the cable adjustment retainer (3) to the unlock position.
  6. Remove the range selector lever cable (4) from the range selector lever cable lever and the range selector lever cable bracket.
  7. Front Floor Console - Remove - Front Floor Console Replacement
  8. GM5115990Courtesy of GENERAL MOTORS COMPANY

    Transmission Range Selector Lever Cable Grommet Nut (1) - Remove [2x]

  9. Transmission Range Selector Lever Cable Retainer (2) Disengage
  10. GM4932626Courtesy of GENERAL MOTORS COMPANY

    Remove the range selector lever cable screw (1) from the transmission control.

    11. NOTE:

    The cable screw (2) is not separated from the range selector lever cable.

  11. Remove the range selector lever cable screw (2) along with the range selector lever cable (3) from the transmission control.
  12. Remove the range selector lever cable from vehicle by pulling it into the interior.
scientia non olet · About LEMON Manuals