LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission - 9T50 (M3E) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Automatic Transmission Range Selector Lever Cable Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM4686788Courtesy of GENERAL MOTORS COMPANY

    Install the automatic transmission range selector lever cable bracket (2).

    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the 2 automatic transmission range selector lever cable bracket bolts (1) and tighten to 22 N.m (16 lb ft).
  3. Install the automatic transmission range selector lever cable to the automatic transmission range selector lever cable bracket. Automatic Transmission Range Selector Lever Cable Replacement 
scientia non olet · About LEMON Manuals