LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission - 9T50 (M3E) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Automatic Transmission Input Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM4487717Courtesy of GENERAL MOTORS COMPANY

    Install the input speed sensor seal (3).

  2. Install the input speed sensor (2).
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the input speed sensor bolt (1) and tighten to 9 N.m (80 lb in).
  4. Connect the input speed sensor electrical connector.
  5. Install the left front wheel house liner. See FRONT WHEELHOUSE LINER REPLACEMENT - LEFT SIDE .
  6. Perform the transmission service fast learn procedure. Transmission Service Fast Learn Procedure.
scientia non olet · About LEMON Manuals