| Automatic Transmission Case (19) |
- Inspect for cracked or broken Case (19) .
- Inspect for stripped or sheared splines.
- Inspect for binding Manual Shift Detent Lever Assembly (709) .
- Inspect for missing Manual Shift Detent Lever Pin (710) .
- Inspect for interference or binding Park Pawl Actuator Assembly (708) .
- Inspect for broken or disengaged 1-2-3-4-5-6 Clutch Piston Housing Return Ring (523) .
- Inspect for loose or damaged case bushing.
- Inspect Automatic Transmission Fluid Pump Shaft Seal (311) for damage.
|
| Torque Converter (14) |
- Inspect for stripped or sheared splines on Turbine Shaft.
- Inspect for missing Torque Converter to Flywheel bolts.
|
| Torque Converter and Differential Housing (13) |
- Inspect for stripped or sheared Front Differential Ring Gear (207) Splines.
- Inspect for broken or disengaged Front Differential Rear Gear Retainer (206) .
- Inspect for loose, missing or broken Torque Converter and Differential Housing bolts (16) .
- Inspect for loose, missing or broken Automatic Transmission Fluid Pump Cover Bolts (200, 211) .
|
| 5-7-Reverse and 6-7-8-9 Clutch Housing (530) |
- Inspect for damaged or broken Input Sun Gear Thrust Bearing (550,553) .
- Inspect for stripped or sheared splines on the Turbine Shaft to the 5-7-Reverse and 6-7-8-9 Clutch Housing (547) .
|
| Automatic Transmission Fluid Pump Assembly (201) |
- Inspect for fluid leaks / improper fluid level.
- Inspect for leaking Fluid Outlet Seal Assembly (24) .
- Inspect for loose or missing Automatic Transmission Fluid Pump Cover Bolt (312) .
- Inspect for damaged, restricted or improperly installed Automatic Transmission Fluid Filter (203) .
- Inspect for damaged or leaking Automatic Transmission Fluid Filter Seal (202) .
- Inspect for broken or seized Automatic Transmission Fluid Pump (315) .
|
| Input Carrier Assembly (552) |
- Inspect for stripped or sheared castle splines to ring gear.
- Inspect for improperly installed carrier pinion gear pins.
- Inspect for damaged or broken Pinion Gears.
- Inspect for stripped or sheared splines on the Input Sun Gear (551) .
- Inspect for damaged or broken Output Carrier (555) .
- Inspect for broken or disengaged Output Internal Gear Retainer Ring.
- Inspect for damaged or brokenInput Carrier Thrust Bearing (549) and Output Carrier Thrust Bearing (554) .
- Inspect for damaged or broken Input Sun Gear Thrust Bearing (550, 553) .
|
| Overdrive Carrier (546) |
- Inspect for stripped or sheared splines.
|
| Output Carrier Assembly (555) |
- Inspect for damaged or broken Input Sun Gear Thrust Bearings (550, 553) .
- Inspect for damaged or broken Pinion Gear teeth.
- Inspect for damaged or broken Input Carrier Thrust Bearings (549) .
- Inspect for broken or damaged Output Internal Gear.
|
| Output Sun Gear Assembly (555) |
- Inspect for broken Output Sun Gear Assembly (555) hub or weld.
|
| 1-Reverse and 1-2-3-4-5-6 Clutch Piston Housing |
Inspect for disengaged or broken 1-2-3-4-5-6 Clutch Backing Plate Retaining Ring (599) . |
| Drive Link (233) |
- Inspect for broken, worn or damaged Drive Link Assembly (233) .
- Inspect for broken, worn or damaged Drive Sprocket (234) .
- Inspect for broken, worn or damaged Driven Sprocket Assembly (241) .
- Inspect for broken Drive Gear Hub (231) .
|
| Front Differential Carrier (238) |
- Inspect for stripped or sheared splines on Differential Side Gear.
- Inspect for stripped or sheared splines Final Drive Sun Gear (230) .
- Inspect for stripped or sheared splines Differential Carrier to PTU (AWD only) .
- Inspect for stripped broken or disengaged Final Drive Retainer (581) .
- Inspect for damaged or broken Pinion Gear teeth.
- Inpsect for damaged or broken Final Drive Rollers (585) .
- Inspect for broken, worn or damaged Final Drive Inner and Outer Thrust Washers (584) .
|
| Control Solenoid (w/Body and TCM) Valve Assembly |
- Check that the Manual Valve (432) is engaged with Manual Shift Detent Lever Assembly (609) .
- Inspect the Control Solenoid (w/Body and TCM) Valve Assembly (7) and verify that it is functioning properly.
|