LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 99 (HVAC - Automatic) >> Diagnostic Information and Procedures >> DTC P1F0A-P1F0D >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition - On / Vehicle - In Service Mode
  2. Verify that no DTC listed in the DTC Descriptor Category is set.
    • If any DTC listed in the DTC Descriptor Category is set 
    1. Ignition/Vehicle - Off
    2. Replace the component: G1 A/C Compressor
    3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
    4. Verify the DTC does not set.
      • If the DTC sets - Replace the component:K114B Hybrid/EV Powertrain Control Module 2
      • Go to next step: If the DTC is not set
    5. All OK.
    • Go to next step: If none of the DTCs listed in the DTC Descriptor Category is set 
  3. All OK.
scientia non olet · About LEMON Manuals