Circuit/System Verification
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition - On / Vehicle - In Service Mode
- Verify no other DTCs are set.
- If any other DTCs are set
- Go to next step: If no other DTCs are set
- Verify DTC P154F is not set.
- If the DTC is set
- Ignition/Vehicle - Off
- Replace the component: G1 A/C Compressor
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify DTC P154F is not set.
- If the DTC sets - Replace the component:K114B Hybrid/EV Powertrain Control Module 2
- Go to next step: If the DTC is not set - All OK.
- Go to next step: If the DTC is not set
- All OK.