Circuit/System Verification
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition - On / Vehicle - In Service Mode
- Operate the component:S146 Window/Outside Rearview Mirror Switch - Driver - Select each position
- {Mirror Folding}Verify the scan tool parameter:Mirror Folding Control Switch = Unfold/Fold
- If not the specified state
Refer to: Circuit/System Testing
- Go to next step: If the specified state
- Perform the scan tool control function:Driver Mirror Fold Motor Command & Passenger Mirror Fold Motor Command - Fold & Unfold
Verify the function:Mirror Folding = Fold & Unfold
- If the component does not work as specified
Refer to: Circuit/System Testing
- Go to next step: If the component works as specified
- If the component does not work as specified
- All OK.