LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 97 (Mirror System) >> Diagnostic Information and Procedures >> Power Mirror Folding Malfunction (With A45) >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Dynamic Test

  1. Ignition/Vehicle - Off
  2. Disconnect the electrical connector:A9 Outside Rearview Mirror
  3. Connect a <p01> A fused jumper wire between the test points: Control terminal 4 & 12 V
    4. CAUTION:

    Complete the testing as quickly as possible in order to prevent overheating and damaging the component.

    • Control circuit terminal 4@Component harness & Ground
    • Control circuit terminal 18@Component harness & Ground
  5. Momentarily connect a jumper wire between the test points: Control terminal 18 & Ground

    Reverse the jumper wires 2 times between the terminals.

    Verify the component works as specified: A9 Outside Rearview Mirror = Fold & Unfold

    • If the component does not work as specified 

      Replace the component:A9 Outside Rearview Mirror

    • Go to next step: If the component works as specified 
  6. All OK.
scientia non olet · About LEMON Manuals