LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 96 (Wiper System And Washer System) >> Diagnostic Information and Procedures >> Washer Malfunction >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition - On / Vehicle - In Service Mode
  2. Verify the scan tool parameter:Windshield Washer Switch = Inactive
    • If not the specified state 

      Refer to: Circuit/System Testing - Test 1

    • Go to next step: If the specified state 
  3. Operate the component:S82 Windshield Wiper/Washer Switch - Pressed

    Verify the scan tool parameter:Windshield Washer Switch = Active

    • If not the specified state 

      Refer to: Circuit/System Testing - Test 1

    • Go to next step: If the specified state 
  4. Perform the scan tool control function:Windshield Washer Relay - -

    InactiveActive

    Verify the component turns On and Off:G24 Windshield Washer Pump

    Verify the scan tool parameter:Windshield Washer Relay Command = InactiveActive

    Verify the component turns On and Off:G24 Windshield Washer Pump

    • If the component does not turn On and Off 
    • Refer to: Circuit/System Testing - Test 2
    • Go to next step: If the component turns On and Off 
  5. All OK.
scientia non olet · About LEMON Manuals