Fastener Specifications
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| 300-Volt Battery Positive and Negative Cable Pass-Through Grommet Fastener | 9 N.m (80 lb in) |
| 300-Volt Battery Positive and Negative Cable Retainer Fastener | 9 N.m (80 lb in) |
| Accessory DC Power Control Module Bolt | 9 N.m (80 lb in) |
| Auxiliary Battery Negative Cable to Cell Battery Module Fastener | 9 N.m (80 lb in) |
| Auxiliary Battery Positive Cable to Cell Battery Module Fastener | 9 N.m (80 lb in) |
| Battery Cover Fastener | 9 N.m (80 lb in) |
| Battery Hold Down Retainer Fastener | 9 N.m (80 lb in) |
| Battery Positive Cable to Engine Wiring Harness Junction Block Fastener | 9 N.m (80 lb in) |
| Battery Positive Cable to Rear Pre-Fuse Junction Block Fastener | 16 N.m (12 lb ft) |
| Cell Battery Module Hold Down Retainer Fastener | 9 N.m (80 lb in) |
| Drive Motor Generator Battery Bracket Nut | 9 N.m (80 lb in) |
| Drive Motor Power Inverter Module Shield Fastener | 9 N.m (80 lb in) |
| High Voltage Battery Cover Reinforcement Fastener | 9 N.m (80 lb in) |
| High Voltage Battery Disconnect Relay Mounting Fastener | 9 N.m (80 lb in) |
| High Voltage Battery Manual Disconnect Connector Fastener | 9 N.m (80 lb in) |
| High Voltage Battery Mounting Fasteners | 22 N.m (16 lb ft) |
| High Voltage Battery Negative Cable to Cell Battery Module Fastener | 9 N.m (80 lb in) |
| High Voltage Battery Positive and Negative Cable Cover Fastener | 9 N.m (80 lb in) |
| High Voltage Battery Positive Cable to Cell Battery Module Fastener | 9 N.m (80 lb in) |
| High Voltage Bus Bar Fastener | 9 N.m (80 lb in) |