Installation Procedure
Cell Battery Module (1) - Install
Battery Hold Down Retainer (2) - Install
- Battery Hold Down Bolt (1) - Install and tighten [2X] 9 N.m (80 lb in)
High Voltage Battery Interface Control Module (1) - Install
Connect the ribbon connector. (1)
Electrical Connector (2) - Connect
- Retainer Clip (3) - Engage
- Battery Vent Tube (1) - Connect
High Voltage Bus Bar (2) - Install
- High Voltage Bus Bar Fastener (1) - Install and tighten [2X] 9 N.m (80 lb in)
Auxiliary Battery Cable (4) - Install - Auxiliary Battery Cable Replacement
- Perform Hybrid/EV battery cell balancing, refer to Hybrid/EV Battery Cell Balancing
Battery Cooling Air Inlet Duct - Front (2) - Install
Battery Cooling Air Inlet Duct- Rear (1) - Install
Battery Hold Down Retainer - Right Side Panel (3) - Install - Battery Hold Down Retainer Replacement (Right Side Panel)
Battery Hold Down Retainer - Left Side Panel (3) - Install - Battery Hold Down Retainer Replacement (Left Side Panel)
Battery Cover - Front (3) - Install - Battery Cover Replacement (Back Panel) , or Battery Cover Replacement (Front Panel)
Battery Cover - Back (2) - Install - Battery Cover Replacement (Back Panel) , or Battery Cover Replacement (Front Panel)
High Voltage Battery Tray Reinforcement - Right Side (1) - Install - High Voltage Battery Tray Reinforcement Replacement (Right Side)
High Voltage Battery Tray Reinforcement - Left Side (1) - Install - High Voltage Battery Tray Reinforcement Replacement (Left Side)
High Voltage Battery (1) - Install - High Voltage Battery Replacement and Shipping Preparation
- Enable the high voltage system. High Voltage Enabling
Refer to Fastener Caution