Installation Procedure
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Battery Hold Down Retainer - Left Side Panel (3) - Install
- Battery Hold Down Retainer Nut (1) - Install and tighten [4X] 9 N.m (80 lb in)
- Install the cell battery vent tube grommet (2) to the top of the battery hold down retainer.
Battery Cover - Front (3) - Install - Battery Cover Replacement (Back Panel) , or Battery Cover Replacement (Front Panel)
Battery Cover - Back (2) - Install - Battery Cover Replacement (Back Panel) , or Battery Cover Replacement (Front Panel)
High Voltage Battery Tray Reinforcement - Right Side (1) - Install - High Voltage Battery Tray Reinforcement Replacement (Right Side)
High Voltage Battery Tray Reinforcement - Left Side (1) - Install - High Voltage Battery Tray Reinforcement Replacement (Left Side)
High Voltage Battery (1) - Install - High Voltage Battery Replacement and Shipping Preparation
- Enable the high voltage system. High Voltage Enabling
CAUTION:
Refer to Fastener Caution