LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (Hybrid/EV Energy Storage System) >> Diagnostic Information and Procedures >> DTC P1F17 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Vehicle in Service Mode.
  2. Verify that no other DTCs are set.
    • Go to next step: If none of the DTCs are set 
  3. Verify that DTC P1F17 is not set.
    • If DTC P1F17 is set 
    1. Verify the K36 Inflatable Restraint Sensing And Diagnostic Module is programmed with the correct software calibration.
      • If the correct software is not installed, program the K36 Inflatable Restraint Sensing And Diagnostic Module.
      • Go to next step: If the correct software is installed
    2. Perform the Clear Secured High Voltage DTCs  repair instruction.
    3. Verify that DTC P1F17 does not set while operating the vehicle within the Conditions for Running the DTC.
      • If DTC P1F17 is set, replace the K114B Hybrid Powertrain Control Module 2.
      • Go to next step: If DTC P1F17 is not set
    4. All OK.
    • Go to next step: If DTC P1F17 is not set 
  4. All OK.
scientia non olet · About LEMON Manuals