LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (Hybrid/EV Energy Storage System) >> Diagnostic Information and Procedures >> DTC P1EBA >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Vehicle ON.
  2. Verify DTC P1EBA is not set.
    • If the DTC is set 
    1. Verify the K114A Hybrid Powertrain Control Module 2 has the latest calibration in Calibration Information.
      • If the K114A Hybrid Powertrain Control Module 2 does not have the latest calibration, program the K114A Hybrid Powertrain Control Module 2.
      • If the K114A Hybrid Powertrain Control Module 2 has the latest calibration, replace the K114A Hybrid Powertrain Control Module 2.
    2. Verify the DTC does not set
      • If the DTC sets, replace the B30 Hybrid/EV Battery Pack Current Sensor.
      • Go to next step: If the DTC does not set
    3. All OK.
    • Go to next step: If the DTC is not set 
  3. All OK.
scientia non olet · About LEMON Manuals