Push Button Start

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

The vehicle has an electronic push button ignition mode switch. The ignition mode switch has 2 LEDs that indicate the vehicle power mode. When the vehicle is in the OFF mode, both LED's will be OFF. Both LED's have the voltage supplied from the body control module (BCM). The ignition mode switch contains two individual switches that provide redundant switch inputs to both the body control module and the keyless entry control module. The body control module supplies the ignition mode switch a constant B+ signal. The body control module monitors this signal to determine if the switch is released or pressed. When the ignition mode switch is not pressed, voltage on the signal circuit is pulled down through two resistors in the switch. When the ignition mode switch is pressed, voltage on the signal circuit is pulled down through only one resistor, changing the voltage seen at the body control module and indicating that the ignition mode switch is pressed. The keyless entry control module monitors voltage on the switch in the same manner as the body control module, but monitors the other individual switch in the ignition mode switch. The PEPS module sends a redundant signal to the BCM with the ignition mode switch status.