Installation Procedure
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Battery Negative Cable (1) - Install
- Battery Negative Cable Ground Fastener (3) - Install and tighten 9 N.m (80 lb in)
- Battery Negative Post Clamp Nut (2) - Tighten 4.5 N.m (40 lb in)
Electrical Connector (1) - Connect
- Body Harness Terminal (3) - Install
- Body Harness Ground Fastener (2) - Install and tighten 9 N.m (80 lb in)
Rear Compartment Side Trim Panel (2) - Install - Rear Compartment Side Trim Replacement - Left Side (With HP4)
CAUTION:
Refer to Fastener Caution