Installation Procedure
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- NOTE:
Install a NEW seal.
Variable Low Clutch Fluid Passage Seal (7) - Install
- Control Valve Lower Body Spacer Plate (6) - Install
- Control Valve Body Spacer Plate Retainer (5) - Install [2x]
- Control Valve Body (4) - Install
- Control Valve Body Bolt (3) - Install [13x] - Hand tighten
- Fluid Transfer Pipe (2) - Install
- Fluid Transfer Pipe Bolt (1) - Install - Hand tighten
- Connect the control valve body wiring harness.
Control Valve Body Bolt @ Fluid Transfer Pipe Bolt - Tighten in sequence 9 N.m (80 lb in)
Control Solenoid Valve Filter Plate (3) - Install
- Control Solenoid Valve (2) - Install
- Control Valve Body Bolt (1) - Install [4x] - Hand tighten
- Connect the control solenoid valve wiring harness.
Control Valve Body Bolt - Tighten in sequence 9 N.m (80 lb in)
- Control Valve Body Cover Replacement - Install
NOTE:
Install a NEW spacer plate.
CAUTION: