Holding Fixture Removal

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Transmission Case WARNING: Handle with care, the transmission assembly weighs over 183 Kg (403 lbs). Bodily injury could occur if not handled properly. Procedure Install DT-46625 Holding Fixture. Remove lock pin from DT-3289-20 Holding Fixture. Raise the transmission with an overhead hoist in order to remove the holding DT-46625 Transmission Holding Fixture. Lower the transmission assembly onto the transmission jack. Special Tools DT-03289-20 Holding Fixture Base Assembly DT-46625 Holding Fixture DT-46625-20 Holding Fixture Adapters For equivalent regional tools, refer to Special Tools .

Callout

Component Name

Transmission Case

WARNING:

Handle with care, the transmission assembly weighs over 183 Kg (403 lbs). Bodily injury could occur if not handled properly.

Procedure

Install DT-46625 Holding Fixture.
Remove lock pin from DT-3289-20 Holding Fixture.
Raise the transmission with an overhead hoist in order to remove the holding DT-46625 Transmission Holding Fixture.
Lower the transmission assembly onto the transmission jack.

Special Tools

DT-03289-20 Holding Fixture Base Assembly
DT-46625 Holding Fixture
DT-46625-20 Holding Fixture Adapters

For equivalent regional tools, refer to Special Tools .