Front Seat Cushion Outer Finish Cover Replacement (Power)

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Front Seat Cushion Outer Finish Cover Fastener [2x] CAUTION: Refer to Fastener Caution . Tighten 2.5 N.m (22 lb in)
2	Front Seat Cushion Outer Finish Cover NOTE: If the hooks are not fully disengaged, damage to the cover will occur. It is necessary to remove both switches before disconnecting the electrical connectors. Procedure Disconnect the outer finish cover from the inner finish cover. Press inward on the outer finish cover just above the switch to disengage the hooks from the retainer and lift upward to remove the outer finish cover. Transfer components as necessary.

Callout

Component Name

Front Seat Cushion Outer Finish Cover Fastener [2x]

CAUTION:

Refer to Fastener Caution .

Tighten
2.5 N.m (22 lb in)

Front Seat Cushion Outer Finish Cover

NOTE:

If the hooks are not fully disengaged, damage to the cover will occur.
It is necessary to remove both switches before disconnecting the electrical connectors.

Procedure

Disconnect the outer finish cover from the inner finish cover.
Press inward on the outer finish cover just above the switch to disengage the hooks from the retainer and lift upward to remove the outer finish cover.
Transfer components as necessary.