Measuring the P and R Dimension
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Measurement Definitions
PHeight: The vertical distance from the ground to the top of the wheel opening through the center line of the front wheel.
RHeight: The vertical distance from the ground to the top of the wheel opening through the center line of the rear wheel.
Use the following procedures to measure the Pand Rdimensions:
- Push the front bumper down a minimum of 25 mm (1 in), and release. Perform this step three times.
- Measure and record the trim height per the "Measurement Definitions" above.
- Lift the bumper up a minimum of 25 mm (1 in), and release. Perform this step three times.
- Measure and record the trim height per the "Measurement Definitions" above.
- The true Pheight measurement is the average of the measurements taken in step 2 & 4. Trim Height Specifications
- Repeat the above steps at the rear of the vehicle for the Rheights.
- If the P & Rheights are outside of the specifications, measure the Z & Dheights.
NOTE:
The left and right Pand Rheight differences should be no more than 12 mm (47 in).