Circuit/System Verification
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Verify DTC B101D is not set. @ K36 Inflatable Restraint Sensing and Diagnostic Module
- If DTC B101D is set
Replace the component:K36 Inflatable Restraint Sensing and Diagnostic Module
- Go to next step: If the DTC is not set
- If DTC B101D is set
- Verify DTC C0186, C0196, C0287 is not set.@ K36 Inflatable Restraint Sensing and Diagnostic Module
- If DTC C0186, C0196, C0287 is set
Perform the following learn procedure:Vehicle Yaw Sensor Learn
- Go to next step: If the DTC is not set
- If DTC C0186, C0196, C0287 is set
- Verify DTC C0186, C0196, C0287 is not set.@ K17 Electronic Brake Control Module
- If any of the DTCs are set
- Replace the component:K36 Inflatable Restraint Sensing and Diagnostic Module
- Under normal operating conditions:Verify the DTC does not set.
- If the DTC sets - Replace the component:K17 Electronic Brake Control Module
- Go to next step: If the DTC is not set
- All OK.
- Go to next step: If none of the DTCs are set
- All OK.