LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 78 (Antilock Brake System - Except Hybrid (Hp4)) >> Diagnostic Information and Procedures >> DTC B2745 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition - On / Vehicle - In Service Mode
  2. Perform the scan tool control function:All Indicators Command - On and Off
    • Traction/Stability Control Indicator = OFF 

      Replace the component:P16 Instrument Cluster

    • Go to next step: Traction/Stability Control Indicator = ON 
  3. Operate the component:S48E Multifunction Switch - Center Console - Active

    Verify the scan tool parameter:Traction Control Switch @ K9 Body Control Module = Active

    • If not the specified state 

      Refer to: Circuit/System Testing

    • Go to next step: If the specified state 
  4. All OK.
scientia non olet · About LEMON Manuals