Driver Information Indicator

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

ABS Warning Indicator

The instrument cluster turns the ABS warning indicator ON when the following occurs:

The instrument cluster performs the bulb check.
The electronic brake control module detects a malfunction which disables the ABS and sends a serial data message to the instrument cluster requesting illumination.

Brake Warning Indicator

The instrument cluster turns the brake warning indicator ON when the following occurs:

The instrument cluster performs the bulb check.
The electronic brake control module detects a fault and sends a serial data message to the instrument cluster requesting illumination.
The body control module detects that the park brake is engaged. The body control module sends a serial data message to the instrument cluster requesting illumination.

Traction/Stability Active Control Indicator

The instrument cluster turns the traction/stability active control system indicator ON when the following occurs:

The instrument cluster performs the bulb check.
The ABS system is in traction control or stability control mode.
The electronic brake control module detects a traction control/stability control occurring and sends a serial data message to the instrument cluster requesting illumination.

Traction Control Off Indicator

The instrument cluster turns the traction control off indicator ON when the following occurs:

The instrument cluster performs the bulb check.
The driver manually disables the traction control by pressing the traction control switch. The electronic brake control module sends a serial data message to the instrument cluster requesting illumination.

Stability Control Off Indicator

The instrument cluster turns the stability control off indicator ON when the following occurs:

The instrument cluster performs the bulb check.
The driver manually disables the electronic stability control by pressing and holding the traction control switch for five seconds. The electronic brake control module sends a serial data message to the instrument cluster requesting illumination.

Traction/Stability Control Indicator

The instrument cluster turns the traction/stability control system indicator ON when the following occurs:

The instrument cluster performs the bulb check.
The electronic brake control module detects a malfunction which disables the traction control or the electronic stability control and sends a serial data message to the instrument cluster requesting illumination.