Installation Procedure

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Rear Stabilizer Shaft Link (1) - Install
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Rear Stabilizer Shaft Link Bolt (2) @Lower Control Arm - Install
Rear Stabilizer Shaft Link Nut (1) @Lower Control Arm - Install and tighten 58 N.m (43 lb ft)
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.

NOTE:
Ensure that there are no gaps in the threadlocker along the length of the filled area of the threads on the shaft. Allow the threadlocker to cure approximately 10 minutes before installation of the nut.

Apply GM specified threadlocker or industry equivalent to the rear stabilizer shaft link bolt threads. Adhesives, Fluids, Lubricants, and Sealers
Rear Stabilizer Shaft Link Bolt@Rear Stabilizer Shaft (2) - Install a NEW bolt.
Rear Stabilizer Shaft Link Nut@Rear Stabilizer Shaft (1) - Install
Tighten the Bolt
1. First Pass: 58 N.m (43 lb ft)
2. Final Pass:45-60 degrees
Lower the vehicle.