Installation Procedure
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Install the NEW wheel stud (1) into the wheel bearing hub flange (2).
- Add enough washers (3) in order to draw the stud into the hub flange (2).
- Install the wheel nut (4) against the washers (3).
- Tighten the wheel nut (4) until the head of the wheel stud (1) is fully seated against the back of the bearing hub flange (2).
- Remove the wheel nut (4) and the washers (3).
- Remove the wheel bearing and hub assembly from the vise.
- Rear Wheel Bearing and Hub Assembly - Install - Rear Wheel Bearing and Hub Replacement
- Install the rear tire and wheel assembly. Tire and Wheel Removal and Installation .