Installation Procedure
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Rear Suspension Upper Lateral Link (1) - Install
Rear Suspension Upper Control Arm Washer (3) - Install
- Rear Suspension Upper Lateral Link Bolt (2) - Install NEW
- Rear Suspension Upper Lateral Link Nut (1) - Install and tighten
- First Pass: 160 N.m (118 lb ft)
- Final Pass: (90 - 105 degrees)
Rear Suspension Upper Lateral Link Inner Bolt (1) - Install NEW and tighten
- First Pass: 160 N.m (118 lb ft)
- Final Pass: (90 - 105 degrees)
- { If equipped }Rear Suspension Position Ball Socket @Rear Suspension Upper Lateral Link - Connect
- Install the rear tire and wheel assembly. Tire and Wheel Removal and Installation
- Remove the support and lower the vehicle.
CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.
CAUTION:
Refer to Fastener Caution .