Installation Procedure
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Rear Coil Spring Lower Insulator (2) - Install
- Rear Coil Spring Insulator (3) - Install
- Rear Coil Spring (1) - Install
Raise the rear suspension lower control arm (1) back into position. Lower Control Arm Replacement
Rear Suspension Lower Control Arm Bolt (2) - Install
Install a NEW bolt.
- Rear Suspension Lower Control Arm Nut (1) - Install
Tighten
- First Pass: 160 N.m (118 lb ft)
- Final Pass: (90 - 105 degrees)
Rear Shock Absorber Bolt (2) - Install
Install a NEW bolt.
- Rear Shock Absorber Nut (1) - Install
Tighten
- First Pass: 160 N.m (118 lb ft)
- Final Pass: (90 - 105 degrees)
Rear Stabilizer Shaft Link Bolt (2) - Install
- Rear Stabilizer Shaft Link Nut (1) - Install
Tighten58 N.m (43 lb ft)
- Remove the support from the rear suspension lower control arm.
- Install the rear tire and wheel assembly. Tire and Wheel Removal and Installation
CAUTION:
Refer to Fastener Caution .
CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.