Installation Procedure

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Rear Suspension Adjust Link (1) - Install
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.

Rear Suspension Adjust Link Inner Bolt (1) - Install

Install a NEW bolt.
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Rear Suspension Adjust Link Cam (2) - Install
Rear Suspension Adjust Link Nut (1) - Install and tighten 90 N.m (66 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Install the rear suspension adjust link outer bolt (2) and washer (3).

Install a NEW bolt.
Rear Suspension Adjust Link Outer Nut (1) - Install
Tighten
1. First Pass: 160 N.m (118 lb ft)
2. Final Pass: (90 - 105 degrees)
Check the rear wheel alignment. Rear Toe Adjustment