Circuit/System Verification
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition - On / Vehicle - In Service Mode
- Verify DTC C056E 4B is not set.
- If the DTC is set
- Perform the necessary programming and setup procedure: K17 Electronic Brake Control Module - Step 4
- Verify the DTC does not set.
- If the DTC sets - Replace the component:K17 Electronic Brake Control Module
- Go to next step: If the DTC is not set
- All OK.
- Go to next step: If the DTC is not set
- All OK.