LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Seat Belt System) >> Diagnostic Information and Procedures >> Seat Belt Indicator Malfunction - Passenger >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition/Vehicle - Off
  2. Disconnect the electrical connector:B88P Seat Belt Switch - Passenger
  3. Test for infinite resistance between the test points:Signal terminal 1 & Low Reference terminal 2 - The switch is in the open position.
    • If less than infinite resistance 

      Replace the component:B88P Seat Belt Switch - Passenger

    • Go to next step: If infinite resistance 
  4. Test for less than 1 ohms between the test points:Signal terminal 1 & Low Reference terminal 2 - The switch is in the closed position.
    • If 2 ohms or greater 

      Replace the component:B88P Seat Belt Switch - Passenger

    • Go to next step: If less than 1 ohms 
  5. All OK.
scientia non olet · About LEMON Manuals