Circuit/System Verification
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition - On / Vehicle - In Service Mode
- Perform the appropriate scan tool control function:All Indicators@A98 Front Overhead Console Assembly - On and Off
Verify the component turns On and Off:Seat Belt Reminder Indicator
- If the component does not turn On and Off
Replace the appropriate component:A98 Front Overhead Console Assembly
- Go to next step: If the component turns On and Off
- If the component does not turn On and Off
- Operate the component:B153P Seat Belt Buckle - Passenger - Buckled
Verify the scan tool parameter:Passenger Seat Belt Status=Buckled
- If not the specified state
Refer to: Circuit/System Testing
- Go to next step: If the specified state
- If not the specified state
- Operate the component:B153P Seat Belt Buckle - Passenger - Unbuckled
Verify the scan tool parameter:Passenger Seat Belt Status=Unbuckled
- If not the specified state
Refer to: Circuit/System Testing
- Go to next step: If the specified state
- If not the specified state
- All OK.