Circuit/System Verification

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Ignition - On / Vehicle - In Service Mode
Perform the appropriate scan tool control function:All Indicators@P16 Instrument Cluster - On and Off
Verify the component turns On and Off:Seat Belt Reminder Indicator
- If the component does not turn On and Off
  Replace the appropriate component:P16 Instrument Cluster
- Go to next step: If the component turns On and Off
Operate the component:B153D Seat Belt Buckle - Driver - Buckled
Verify the scan tool parameter:Driver Seat Belt Status=Buckled
- If not the specified state
  Refer to: Circuit/System Testing
- Go to next step: If the specified state
Operate the component:B153D Seat Belt Buckle - Driver - Unbuckled
Verify the scan tool parameter:Driver Seat Belt Status=Unbuckled
- If not the specified state
  Refer to: Circuit/System Testing
- Go to next step: If the specified state
All OK.