LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 70 (Automatic Transmission Cooling System) >> Repair Instructions >> Transmission Fluid Cooler Inlet Pipe Replacement (LFV with MRG (from the transmission to the transmission fluid cooler inlet pipe)) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM4231332Courtesy of GENERAL MOTORS COMPANY

    Battery Tray (2) - Remove Battery Tray Replacement (LFV)

  2. Place a drain pan under the vehicle.
  3. GM5129695Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Cover or plug all open transmission fluid cooler pipe connection points to help avoid any accidental contamination.

    Transmission Fluid Cooler Inlet Pipe (1) @ Transmission Fluid Cooler Inlet and Outlet Pipe - Disengage - Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection 

  4. Transmission Fluid Cooler Inlet Pipe (1) @ Transmission Fluid Cooler Inlet Pipe Clip (2) - Unclip
  5. GM5120675Courtesy of GENERAL MOTORS COMPANY

    Front Wheelhouse Front Liner-Left Side (3) - Remove - Front Wheelhouse Liner Replacement - Left Side

  6. GM5129693Courtesy of GENERAL MOTORS COMPANY

    Transmission Fluid Cooler Inlet Pipe Clip (1) - Disengage

  7. Transmission Fluid Cooler Inlet Pipe Nut (4) - Remove
  8. Transmission Fluid Cooler Inlet Pipe (2) - Remove
  9. Remove and DISCARD the seal. (3)
  10. Remove the transmission fluid cooler inlet pipe (2) from the vehicle.
scientia non olet · About LEMON Manuals