LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Power Steering System) >> Diagnostic Information and Procedures >> Rattle, Clunk, Pop or Shudder Noise from the Power Steering System

Rattle, Clunk, Pop or Shudder Noise from the Power Steering System

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Condition Action
Verify the customer complaint Test the vehicle on a shop hoist or road test.
It may be necessary to compare to a like vehicle to determine if an issue is present.
DTCs are present Confirm and repair the condition that set DTC. Diagnostic Starting Point - Vehicle
Loose, worn or damaged outer tie rod ends. Lubricate the outer tie rod ends.
Inspect the outer tie rods. Steering Linkage Outer Tie Rod Inspection 
Loose, worn or damaged inner tie rod ends. Inspect the inner tie rods. Steering Linkage Inner Tie Rod Inspection 
Loose, worn or damaged ball joints. Inspect the ball joints. Ball Joint Inspection
Loose, worn or damaged upper intermediate steering shaft. Replace the upper intermediate steering shaft. Upper Intermediate Steering Shaft Replacement
Loose, worn or damaged intermediate steering shaft. Replace the intermediate steering shaft. Intermediate Steering Shaft Replacement
Loose, worn, fluid leaks or damaged electric dual pinion rack and pinion steering gear bushings. Replace the electric dual pinion rack and pinion steering gear. Electric Dual Pinion Rack and Pinion Steering Gear Replacement 
Noise at the steering column. Inspect fasteners and tighten, if necessary. Steering Column Replacement
Replace the steering column. Steering Column Replacement
Noise at the electric dual pinion rack and pinion steering gear. Inspect fasteners and tighten, if necessary. Fastener Specifications 
Noise at the electric dual pinion rack and pinion steering gear. With the intermediate shaft disconnected, use a wrench to rotate the steering gear input shaft from the left of center to the right of center. If the power steering assist motor damage is identified, replace the power steering assist motor. Power Steering Assist Motor Replacement 
Noise at the electric dual pinion rack and pinion steering gear. With the intermediate shaft disconnected, use a wrench to rotate the steering gear input shaft from the left of center to the right of center. If the electric dual pinion rack and pinion steering gear is worn or damaged, replace the electric dual pinion rack and pinion steering gear. Electric Dual Pinion Rack and Pinion Steering Gear Replacement 
Noise at the steer gear boots. Replace the steering gear boot.
Noise in the front wheel drive shaft inner joint or boot. Replace the front wheel drive shaft inner joint or boot. Front Wheel Drive Shaft Inner Joint and Boot Replacement
Noise in the front wheel drive shaft outer joint or boot. Replace the front wheel drive shaft outer joint or boot. Front Wheel Drive Shaft Outer Joint and Boot Replacement