LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 65 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Rear Side Door Adjustment >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Up/Down or In/Out Adjustment

  1. Open the door.
    2. NOTE:

    The door side upper and lower hinge bolts must remain tight enough to retain door adjusted position.

  2. Apply a double layer of masking tape around the perimeter of the painted surfaces.

    Loosen the door side hinge bolts.

    Do NOT remove the bolts from the door.

  3. Adjust the door up or down by repositioning the door as necessary.
  4. Adjust the door in or out by repositioning the door as necessary.


Fore/Aft Adjustment

    NOTE:

    The door side upper and lower hinge bolts must remain tight enough to retain door adjusted position.

  1. Apply a double layer of masking tape around the perimeter of the painted surfaces.

    Loosen the bodyside hinge bolts, but do NOT remove the bolts from the door.

  2. Adjust the door fore and aft by repositioning the door as necessary.
scientia non olet · About LEMON Manuals