LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Automatic Transmission - 9T50 (M3E) - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0711-P0713 >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition/Vehicle - Off
  2. Remove the component:Transmission Cover
  3. Disconnect the electrical connector:X1 @ T12 Automatic Transmission Assembly
  4. Test for 45 to 44000 ohms between the test points:Signal terminal 23 & Low Reference terminal 22
    • If not between 40 and 45000 ohms 

      Replace the component:B13 Transmission Fluid Temperature Sensor

    • Go to next step: If between 40 and 45000 ohms 
  5. Verify the value is within the range listed in the table:Refer to:Temperature Versus Resistance
    • If not in the specified range 

      Replace the component:B13 Transmission Fluid Temperature Sensor

    • Go to next step: If in the specified range 
  6. All OK.
scientia non olet · About LEMON Manuals