Circuit/System Verification
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition - On / Vehicle - In Service Mode
- Verify the scan tool parameter:Trunk Lid/Liftgate Window Exterior Unlatch Switch = Inactive
- If not the specified state
Refer to: Circuit/System Testing - Test 1
- Go to next step: If the specified state
- If not the specified state
- Operate the component:S58A Rear Compartment Lid Unlatch Switch - Exterior - Pressed
Verify the scan tool parameter:Trunk Lid/Liftgate Window Exterior Unlatch Switch = Active
- If not the specified state
Refer to: Circuit/System Testing - Test 1
- Go to next step: If the specified state
- If not the specified state
- Perform the scan tool control function:Trunk Lid Unlatch Command - Unlatch
Verify a click can be heard or felt at the component when the scan tool control function was commanded:M40 Rear Compartment Lid Latch
- If a click cannot be heard or felt
Refer to: Circuit/System Testing - Test 2
- Go to next step: If a click can be heard or felt
- If a click cannot be heard or felt
- All OK.