Circuit/System Verification
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition - On / Vehicle - In Service Mode
- Operate the component:Trunk Lid - Closed
Verify the scan tool parameter:Rear Closure Ajar Switch = Inactive
- If not the specified state
Refer to: Circuit/System Testing
- Go to next step: If the specified state
- If not the specified state
- Operate the component:Trunk Lid - Ajar
Verify the scan tool parameter:Rear Closure Ajar Switch = Active
- If not the specified state
Refer to: Circuit/System Testing
- Go to next step: If the specified state
- If not the specified state
- All OK.