Circuit/System Verification

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Ignition - On / Vehicle - In Service Mode
Verify the scan tool parameter:
- Exterior Driver Door Handle Switch = Inactive
- Exterior Passenger Door Handle Switch = Inactive
- Exterior Left Rear Door Handle Switch = Inactive
- Exterior Right Rear Door Handle Switch = Inactive
- If not the specified state
  Refer to: Circuit/System Testing
- Go to next step: If the specified state
Operate the component:B27D Door Handle Switch - Driver Exterior - Pressed
Verify the scan tool parameter:Exterior Driver Door Handle Switch = Active
- If not the specified state
  Refer to: Circuit/System Testing
- Go to next step: If the specified state
Operate the component:B27P Door Handle Switch - Passenger Exterior - Pressed
Verify the scan tool parameter:Exterior Passenger Door Handle Switch = Active
- If not the specified state
  Refer to: Circuit/System Testing
- Go to next step: If the specified state
Operate the component:B27LR Door Handle Switch - Left Rear Exterior - Pressed
Verify the scan tool parameter:Exterior Left Rear Door Handle Switch = Active
- If not the specified state
  Refer to: Circuit/System Testing
- Go to next step: If the specified state
Operate the component:B27RR Door Handle Switch - Right Rear Exterior - Pressed
Verify the scan tool parameter:Exterior Right Rear Door Handle Switch = Active
- If not the specified state
  Refer to: Circuit/System Testing
- Go to next step: If the specified state
All OK.