Installation Procedure
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Position the engine wiring harness junction block (1) to the vehicle and push down until the retainer tabs and lock into place.
Electrical Connector (1) - Connect [3x]
- Connect any harness retainers.
Auxiliary Battery Positive Cable (2) - Install
- Auxiliary Battery Positive Cable Nut (1) - Install and tighten 16 N.m (12 lb ft)
Engine Wiring Harness Junction Block Cover (1) - Install
Engine Wiring Harness Junction Block Upper Cover (1) - Install
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (Without KL9) , or Battery Negative Cable Disconnection and Connection (With KL9)
CAUTION:
Refer to Fastener Caution .