Conditions for Setting the DTC
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
There is a running calibration change for model year 2017 and a service release for model year 2016. Re-program the controller first and then check the following conditions.
Either of the following conditions is detected 33 seconds after the Conditions for Running the DTC have been met:
- Drive Motor A torque is greater than 4 N.m.
OR
- Engine speed is greater than 200 RPM.