LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Hybrid/EV Controls) >> Diagnostic Information and Procedures >> DTC P3260 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify DTCs that inhibit Autostop operation, or stuck clutch DTCs P07A3 or P07A5, or pressure controls solenoid DTCs P0960, P0962, or P0963 are not set.
    • Go to next step: If none of the DTCs are set 
  2. Verify DTC P3260 is not set.
    • If the DTC is set 
    1. Verify the T6 Power Inverter Module has the latest calibration in Calibration Information.
      • If the T6 Power Inverter Module does not have the latest calibration, program the T6 power inverter module.
      • If the T6 Power Inverter Module has the latest calibration, replace the T6 Power Inverter Module.
      2. NOTE:

      The transmission must be in Neutral for greater than 33 seconds.

    2. Vehicle ON, verify the DTC does not set.
      • If the DTC sets, replace the T6 Power Inverter Module.
      • Go to next step: If the DTC is not set
    3. All OK.
    • Go to next step: If the DTC is not set 
  3. All OK.
scientia non olet · About LEMON Manuals